Braeburn 3300 Bedienungsanleitung PDF herunterladen

Premier Series

Non-Programmable Thermostats

Important Safety Information

WARNING

• Always turn off power to the air conditioning or heating system prior to

installing, removing, cleaning or servicing thermostat.

• This thermostat is a dual power thermostat and either requires 24 Volt

AC Power or two (2) properly installed “AA” Alkaline batteries for normal

operation and control of the heating or cooling system.

• This thermostat should only be used as described in this manual. Any other

use is not recommended and will void the warranty.

Replacing Existing Thermostat

Most existing thermostats have three parts:

• The cover, which may snap or hinge over the existing thermostat.

• The electronics or body, which controls the existing system.

• The sub-base, where the wires attach through the wall to the existing system.

1. Always turn off power to the air conditioning and heating system prior to

removing existing thermostat.

2. Carefully remove the cover and electronics body from the old thermostat

sub-base. Depending on the brand, these parts may pull off or need to be

unscrewed. The old sub-base should remain wired and on the wall until

steps 4 and 5.

3. Label every old wire with the letter of the connection to which the wire is

attached. Example letters are R, M, Y, etc. Depending on the brand of the

old thermostat, your letters may be different.

MODEL

3300

Multi-Stage 3 Heat / 2 Cool

Auto Changeover

Conventional and Heat Pump

Before Installing or Operating,

PLEASE READ ALL INSTRUCTIONS

1 Speciﬁcations

2 Installation

3 Quick Reference

4 Programming

Installer Settings

5 Programming

User Settings

6 Additional Operation

Features

7 Testing Thermostat

8 Troubleshooting

9 Wiring Diagrams

Speciﬁcations

• Electrical Rating: 24 Volt AC (18-30 Volt AC)

1 amp maximum load per terminal

5 amp maximum load (all terminals)

• Control Range: 45º - 90º F (7º C - 32º C)

• Accuracy: +/- 1º F (+/- .5º C), +/- 3% RH

• AC Power: 18-30 Volt AC

• DC Power: 3.0 Volt DC (2 “AA” Alkaline batteries included)

• Compatibility: Compatible with low voltage single stage or multi-stage heat / cool

systems, including heat pumps with up to three stages of heating and two stages of

cooling (three stage heating available on heat pump systems). This thermostat can

also be used on 250 to 750 millivolt heating only systems.

• Terminations: G, Rc, Rh, W2, B, O, Y1, Y2, W1/E/W3, C, L, S1, S2

Installation

Old Terminal from

Existing Thermostat

New Terminal for

New Thermostat

(Model 3300)

Terminal Description

G or F G Fan Control

Rc Rc 24 Volt AC (Cooling for

Dual Transformer Systems)

R, V-VR or VR-R Rh 24 Volt AC

W1, W2 or W-U W2 Stage 2 Heating

B B Reversing Valve (Heating)

O or R O Reversing Valve (Cooling)

Y, Y1 or M Y1 Stage 1 Compressor

Y2 Y2 Stage 2 Compressor

W1/E/W3 W1/E/W3 1st Stage Heating for

Conventional Systems or

Emergency Heating for 3

Stage Heat Pumps

C, X or B C 24 Volt AC, Transformer

Common

L or X L System Malfunction Indicator

S1 S1 Optional Remote Sensor

S2 S2 Optional Remote Sensor

4. After labeling the old wires, loosen each connection and remove them from

the old sub-base. Secure the wires to prevent them from slipping into the

opening in the wall.

5. Remove the old sub-base from the wall, again being careful that the wires

do not slip into the opening in the wall.

6. Use the chart on page 1 to determine the new thermostat connections.

As an example, if the old thermostat had a G or F connection, it goes to

G on the new thermostat. It may be helpful to use the chart by circling

(with a pencil or pen) the letter of each wire removed from the old thermostat.

1 2 3 4 5 6 ... 12 13

Inhaltsverzeichnis

Seite 1 - Premier Series

Premier SeriesNon-Programmable ThermostatsImportant Safety InformationWARNING• Always turn off power to the air conditioning or heating system prior t

Seite 2 - Installation

178Troubleshooting cont.Symptom: Cannot program a set point temperature higher than 90˚ F (32˚ C).Potential Solution: This is above the normal thermos

Seite 3 - Quick Reference

Factory Installed Jumper1st StageCompressorControl2nd StageCompressorControl(NOTE 2)2nd StageHeat Control(NOTE 2)RemoteSensor(NOTE 3)Transformer Commo

Seite 4

EmergencyHeat Control(See NOTE 4)1st StageCompressorControl2nd StageCompressorControl(NOTE 2)2nd StageHeat Control(NOTE 2)Fan ControlRemoteSensor(NOTE

Seite 5 -  60 60 12

Braeburn Systems LLC 2215 Cornell Avenue • Montgomery, IL 60538Technical Assistance: www.braeburnonline.comCall us toll-free: 866-268-5599 (U.S. Only)

Seite 6 - SRVC

22Installation cont.NOTE: This thermostat is designed for use on low voltage 24 volt AC single stage or multi-stage systems, including heat pumps wit

Seite 7 - Programming User Settings

44Programming Installer SettingsFunction Status After CLEAROperation mode OFF, Auto Changeover enabledFan Switch AUTORoom temperature Display 70°

Seite 8

64Programming Installer Settings cont.Press the NEXT and buttons at the same time to enter Installer Mode. Factory Installer Options Default

Seite 9 - Read BEFORE Testing

8Installer Option Descriptions continued9. This thermostat includes an automatic compressor protection feature to avoid potential damage to the com

Seite 10 - Troubleshooting

102. Press the or buttons to set the ﬁrst stage differential to your desired setting of 0.2˚, 0.5˚ or 1˚ F (0.1˚, 0.3˚ or 0.5˚ C).3. For Tw

Seite 11 - Wiring Diagrams

126Additional Operation FeaturesChanging Set Temperature1. Press and hold or button for more than 1 second. The entire display will ﬂash once

Seite 12

146Additional Operation Features cont.Status IndicatorsThree status indicators can be displayed to notify you of key system information.AUX: This wil

Seite 13 - Store this

Test Type System Function System Type Active Terminals Cooling 1st Cooling Stage Conventional Y1, O, G or Heat Pump Cooling 2nd C

Weitere Dokumente für Ausrüstung Braeburn 3300

Um das Dokument anzuzeigen Braeburn 3300 Bedienungsanleitung

Braeburn 3300 Bedienungsanleitung (25 Seiten)

Kommentare zu diesen Handbüchern

Keine Kommentare

Braeburn 3300 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Ausrüstung Braeburn 3300 herunter. Braeburn 3300 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Weitere Dokumente für Ausrüstung Braeburn 3300

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Braeburn 3300